Перейти к содержимому

Как правильно помыть радиатор пежо партнер

  • автор:

Чистка радиаторов

Всем привет!Давно хотел навести чистоту под капотом, но руки не доходили, а тут появился повод. Зимой всё было ок, но по весне двигатель начал держать температуру выше нормы. Дождавшись хорошей погоды, решил основательно помыть машину от зимней грязи.Планировал вычистить под напором арки, днище, всё скрытые полости, подкапотку, а заодно и отмыть радиаторы.Хотелось обойтись малой кровью не снимая бампер, но всё же без демонтажа не обошлось. Для удобства рекомендую вывесить передние колёса и снять локеры, под ними куча засохшей грязи и прямой доступ к креплениям переднего бампера. Далее его остаётся открутить снизу от защиты и несколько креплений сверху. Так же не забываем вытащить фишку противотуманок с левой стороны на бампере.далее снимаем бампер и видим такую картину

Фото в бортжурнале Peugeot Partner Tepee За 4 года эксплуатации, между радиаторами скопился очень плотный слой из тополиного пуха и грязи, пришлось смывать в несколько заходов разной химией Фото в бортжурнале Peugeot Partner Tepee Отмывались очень долго Фото в бортжурнале Peugeot Partner Tepee

попутно вычистил всю грязь под капотом и собрал в обратном порядкедке

Фото в бортжурнале Peugeot Partner Tepee

Процедура дала о себе знать, температура нормализовалась и эффективнее стал работать кондиционер. Подкапотное пространство тоже помыл, совсем другой вид! Всем советую)

Форум Пежо 308 Клуб

Радиаторы не мыты с 2008 г.
Как отмыть самостоятельно бутерброд из радиаторов?

Пы.Сы. Если такая тема была, ткните носом

Сообщение mich67 » Пт апр 22, 2016 22:17

Сообщение vingor » Пт апр 22, 2016 22:23

Сообщение kostet » Пт апр 22, 2016 22:46

Сообщение yrk » Пт апр 22, 2016 23:01

Сообщение kostet » Пт апр 22, 2016 23:22

Сообщение artyomovm » Сб апр 23, 2016 8:32

Сообщение yrk » Сб апр 23, 2016 9:41

Сообщение NAK » Сб апр 23, 2016 9:46

Сообщение NAK » Сб апр 23, 2016 13:21

Сообщение artyomovm » Сб апр 23, 2016 13:36

Сообщение mich67 » Сб апр 23, 2016 13:46

Сообщение MadElvis » Сб апр 23, 2016 14:55

Сообщение yrk » Сб апр 23, 2016 15:09

Сообщение MadElvis » Сб апр 23, 2016 16:56

смена антифриза обязательна? (просто года ещё не прошло как новый залил после смены термостата)

How to clean the radiator on Peugeot Partner?

The overheating indicator lights up on the dashboard of your Peugeot Partner? Or only you wish maintain your Peugeot Partner? Cleaning the radiator is a good reflex. Indeed the radiator is a crucial element of the cooling mechanism of your car, so if it is not well maintained you run the risk of overheating the engine, which could to damage some parts. This is why in this tutorial we will show you how to clean the radiator on Peugeot Partner and we will also explain what is it for et why it is necessary to maintain it frequently.

The method to clean the radiator on Peugeot Partner?

Precautions to be taken to clean the radiator of a Peugeot Partner:

First you have to take the security measures adequate because you will handle chemical products. So we advise you to do the cleaning dehors so that the scents evaporate. You will also need to bring gloves and mask so as not to be in contact with irritating substances. Then you should also plan to to recycle the purged liquid because it is particularly polluting. To do this, it is possible to go to a nearby garage or a recycling center.

When you are well protected, you will have to wait for the engine cool. Indeed if you do not wait long enough you take the risk of burning yourself with vapors or coolant. You should know that the temperature of an engine is around 90 degrees, so we advise you to wait at least one hour for it to cool down properly.

Drain the radiator coolant on Peugeot Partner:

After that open the hood of your vehicle, locate the radiator which is located near the engine block, at the front of the car. You should recognize it quickly because it is a metal grid. You have to start with lightly clean the outside of the radiator using a brush and soapy water. This will remove the dirt that has settled between the fins. This is important because when the radiator is covered with dust, the air will not be able to pass properly, which is what allows the circuit to cool.

When you have brushed the exterior, locate the bleed screw present on one of the ends at the bottom of the radiator, this will allow you to drain the radiator. To do this, place a bowl under the vehicle to be able to recover and recycle the coolant that will flow out during the emptying. Be aware that it is not allowed to throw this liquid in pipes such as the sink or toilet. Loosen the bleed screw and wait a while so that all the liquid flows out.

Clean the Peugeot Partner radiator:

As soon as the emptying is carried out, put aside the liquid to recycle it and take a second bowl. After that close the bleed screw and put some cleaning liquid radiator provided for this purpose with the water. Small warning, the cleaner must be adapted to the type of radiator, if it is aluminum or copper, do not hesitate to consult the maintenance guide for your Peugeot Partner. Start the engine about 10 minutes to circulate the cleaner through the mechanism. And after turning it off, wait for the engine to cool down. Reopen the drain plug and let the product flow out.

Then with a garden hose rinse with water inside the radiator by letting water run for a while. When this is done, Wait that all the water drains. Then close the drain plug securely and reinsert antifreeze, about between 5 and 7 liters according to the recommendations provided in the maintenance guide for your Peugeot Partner.

Restart the engine for approximately 10 minutes with the hood open to let the new coolant through. Finally, control levels and add more liquid if necessary.

Why should I clean the radiator on Peugeot Partner?

What is the radiator for Peugeot Partner for?

The radiator is a really essential component of your Peugeot Partner. The engine of your Peugeot Partner will indeed heat up in order to create energy. However, it is essential to control the temperature for prevent overheating which could damage other components. To do this coolant circulates at the engine level. However, the latter will also end up rising in temperature, but it is the role of the radiator of cool the coolant. To do this, the coolant will pass inside the radiator pipes in order to cool itself with the help of the air which circulates between the pipes and directed by fins.

When to clean the radiator on Peugeot Partner?

Now that you know the role of the radiator in your Peugeot Partner, you will understand that it will be really essential to maintain it properly. In general it is advisable to do the maintenance, more precisely the draining and changing the coolant of the radiator about every 2 years.

In case the overheating warning light goes off, this means that your car’s engine is not cooling enough, which could damage components, we recommend that you stop for a while to allow the system to cool down and then head to a professional without waiting. In general this breakdown will be linked to the radiator which is not functioning properly. Effectively as the radiator can scale up and then obstruct therefore it will not be able to cool the coolant.

To finish: it is necessary to properly maintain your Peugeot Partner and especially its cooling mechanism. In this way we recommend that you bleed the radiator and replace the coolant once every two years to ensure that there are no deposits that could clog the pipes and create overheating.

If you have observed a leak during cleaning, do not hesitate to consult the following article: Peugeot Partner air conditioning gas leak, what to do? .

To discover other tutorials on the Peugeot Partner, do not hesitate to consult the other articles on the Peugeot Partner.

Peugeot Partner (B9). Руководство — часть 46

ВНИМ АНИЕ : Обязательно заменять прокладку (2).

Уплотнение (2) (новый)

Датчик (1) ; Затяните моментом 2,7 ± 0,2 дН.м

Подсоедините разъем ( в "a").
Установить защитный щиток под двигателем .

ВНИМ АНИЕ :  Выполните  операции,  которые  необходимо  выполнить  после  снятия  аккумуляторной
батареи.

Добавить комментарий

Ваш адрес email не будет опубликован. Обязательные поля помечены *